Initially I feel there are irony sound bumped against at the time of I to release clutch. This noise I have felt when I to buy this car however still I have not felt correctness thus that moment I still hush.However longer I let, the noise increasingly bothers and felt there are drone sound in car.
I think there are problem with transmission shaft from gear box to cardan, usually this thing indicates universal joit/cross joit there are problem and needs in replace and must as soon as possible because will do a real long voyage if this thing is in letting, if this thing is in letting a real worrying of will destroy. If remain to is let can result damage at sil cardan and seal gearboks. Rotation causality of couples that is is not balance, sometime later makes seal swell and oli can be seep exit. even which more hard of couples axis can be release.
Finally vacation arrives, I can change that universal joint.
Device applied only hammer, spanner wrench and ring key 12, nail puller snapring.
Firstly, ascertains car in a state of locked brake arms, when needed frontage wheel shim and abaft.
By using nail puller snapring, releases to four snapring at yoke
Tapping the yoke with a hammer completely remove the bearing race.
Take out the bearing race on the other side in same way
Prepares universal of cross joint which is new, before in tide adds grease if required at all of bearing race
Tide one of bearing at one of yoke, by the way of beating slowly
enters spinder at yoke obliquely by entering spinder at yoke which has not there are bearing like seems to drawing following
Then enters bearing race at other yoke side, then beats coming up with correct position attached all rings clip.
Attached yoke which have been attached with spinder and the bearing to propeller, previous have been attached one of bearing race
Universal tide of join at other propeller side by the way of like above way, if completed propeller tide at your automobile.
Simply hardly easy to change this Universal joint.
Baca Juga Artikel Terkait
By using nail puller snapring, releases to four snapring at yoke
Tapping the yoke with a hammer completely remove the bearing race.
Take out the bearing race on the other side in same way
Prepares universal of cross joint which is new, before in tide adds grease if required at all of bearing race
Tide one of bearing at one of yoke, by the way of beating slowly
enters spinder at yoke obliquely by entering spinder at yoke which has not there are bearing like seems to drawing following
Then enters bearing race at other yoke side, then beats coming up with correct position attached all rings clip.
Attached yoke which have been attached with spinder and the bearing to propeller, previous have been attached one of bearing race
Universal tide of join at other propeller side by the way of like above way, if completed propeller tide at your automobile.
Simply hardly easy to change this Universal joint.
No comments:
Post a Comment